Choose two large sockets, one that fits over the large end of the bushing where.

Sep 21, Find a wooden dowel slightly larger than the inside diameter of the bushing. Sand the dowel so it fits snuggly in to the bushing.

Helena St.

Pack the bushing full of grease. Insert the dowel and tap it with a hammer. The idea is that the grease will have no where to go and can't compress so it will force the bushing out. Alternatively you can drill it out.

Effective date:

center of the bushing. A plain #10nut tree removal silsbee tx used as the “pry bar” in the tool.

To remove the bushing, just assemble the tool as illustrated below (left illustration) and turn the nut slowly. Be sure the head of the screw is smaller than the bushing O.D. so that it will go through the bushing hole. Feb 20, In this video, I cover how to easily install rubber bushings w/o a press in your treenotch.bar a tab and slot welding table kit here - treenotch.bar#_l_9u.

A special purpose tool for manual installation and removal of bushings or sleeve bearings from press fit bearing housings within automotive engines, transmissions, and other machinery with no resultant damage to the housing is disclosed.

The present tool is comprised of a cylindrical body member including a pilot diameter, which aligns the tool in coaxial relation to the bushing and a bushing.

Aug 16, Simply set up the press with a large cup on the arm that is large enough to accept the outer shell. Select a driver that matches the diameter of the outer shell for the inside of the control arm bushing (where you will be pressing it out), and slowly drive the control arm bushing out. Reverse the operation to install the new bushing. The first step in removal is to loosen and remove all screws or bolts from your assembly.

Once separated, take and thread them into the removal holes in the bushing. Alternately tighten to remove the bushing. If either the QD or split-taper bushing is challenging to remove, place a wedge between the bushing flange and component hub.