Log in.

Jun 15, Is the V groove in the pulley over the Tapered bush? If so: 1. Drill four small holes 90 degrees apart at the bottom of the groove. 2. Thread the holes and with the pulley mounted on the taper screw in 4 bolts with points on just tight enough to mark the tapered bush.

3. Remove the pulley and drill four shallow holes where the bush was marked. 4. Apr 25, treenotch.bar oman. 1. To remove the alternator pulley, use an impact wrench to loosen the nut with one hand, while holding the alternator pulley with the other. It is recommended that protective gloves and eyewear be used. The pulley nut uses standard, right-hand threads. So to remove, rotate in a counter-clockwise direction.

Jul 23, The FACE of the bushing (top most in this picture) is installed nearest to the end of the shaft so it is easy to use the jacking bolts and easily remove the pulley.

Simply remove these bolts and then install the jacking bolts. In the photo you can see that the bushing is NOT brought in tight against the pulley. Feb 28, You can polish off the shaft (an add the flat where the set screw rests), press in new bushings and reassemble.

If you caught the issue in time and the bushings are not worn so much that the shaft is lose you should be in good shape. You must have noticed a problem in the first place to want to remove the shaft so you might be in the same boat I am.

Aug 17, Agri Supply is proud to stock a wide selection of Motor Pulleys & Bushings along with our huge variety of agriculture, gardening, cooking and outdoor products. We stand behind all 26, items we sell with our Satisfaction Guarantee. Customer Service is the cornerstone of our family business, and has been for over 50 years. used stump grinder remove motor pulley bushing