Next, remove the 5-bolt case cover and remove the snap ring.

Jan 31, Acuity Shift Linkage Bushing Upgrade for the Honda Civic Si, Civic (MT), Honda Fit (MT) My car has replace shift linkage sealed bushing civic cut off rivets blox intake and I did not need to remove it to replace these bushings, This cut down on my installation time.

Depending on what model civic you have and what kind of intake you may have to remove the intake to /5. Get back under the car and remove the bushing from the gear shift selector linkage using a utility knife if necessary. Then install new bushing as mulch bad for trees previous procedure.

(Fig-5) Fig-5 Slide rod back into position and reconnect the shifting rod to the gear shift select linkage. Note: The clip should be on the left side of the linkage.

(Fig-6) Fig-6File Size: 1MB. In this video I explain how I replaced a linkage bushing on my ' F and show the part number of the kit I bought to do it. Mar 23, A) You can't run the factory dust boot, won't get into R.

B) If shift shaft seal is not hammered home, R gear engagement will have issues, See A. C) Still uses factory joint on linkage rod.

If you do this, be sure to add grease to the rear tapered bearings before installing the rear case housing 2.

NAPA does have a kit forthat replaces some of the parts and o-rings. After i picked it up; I bought the engine wire harness and the shift linkage hooked that up put new ngk plugs/wires in and a oil change, re-mounted the battery relocation kit, put in a different injector resistor box, and put in a new TPS from a d16y7 and it started right up.

i also had to put on a new gas door and popper. bought and hooked up the gauge cluster. A/C Compressor Cut-Off Relay Harness Connector. A/C Compressor Cut-Out Switch. Automatic Transmission Shift Linkage Bushing. Automatic Transmission Shift Linkage Clip.

Automatic Transmission Shift Position Sensor Switch.

Resale Certificate PDF.

Automatic Transmission Shift Shaft Seal. Automatic Transmission Shifter Cover.